GEN102: Starting Up Your Kuntze Analyzer

This course will take ~20 minutes to complete. Lessons 1-6 are relevant to all users, while lessons 7-10 are about establishing control outputs, which may not be applicable to all users.

If you have not registered to take this course, click here to complete your registration. If you have registered, but lessons appear red, wait 60 seconds and then refresh this page.

Note: Please do not use Microsoft Edge to access courses. Chrome is the preferred browser. 


Available Lessons

Lesson 1 - Configure pH Settings (0:52)
Lesson 2 - Configure DIS Settings (2:12)
Lesson 3 - Configure Temperature Settings (0:39)
Lesson 4 - Calibrate pH Sensor (3:31)
Lesson 5 - Manually Clean DIS Sensor (1:24)
Lesson 6 - Calibrate DIS Sensor (2:12)
Lesson 7 - Sending a 4-20 mA Output (0:51)
Lesson 8 - Controlling Via a 4-20 mA Output (1:29)
Lesson 9 - Control Via a Relay (0:45)
Lesson 10 - Configure Alarm Settings (1:31)
Take the Quiz (6 Questions)

GEN102 - Description

This course covers best-practices installation, settings input, and calibration. If you have any questions, please contact a Kuntze representative at support@kuntze.com.

Ready for start-up? Check out Kuntze's Registration and Start-Up Tutorial.