Course 3: Starting Up Your Kuntze Analyzer
This course will take ~20 minutes to complete. Lessons 1-6 are relevant to all users, while lessons 7-10 are about establishing
control outputs, which may not be applicable to all users.
Note: Please do not use Microsoft Edge to access courses. Chrome is the preferred browser.
Available Lessons
Lesson 1 – Configure pH Settings (0:52)
Lesson 2 – Configure DIS Settings (2:12)
Lesson 3 – Configure Temperature Settings (0:39)
Lesson 4 – Calibrate pH Sensor (3:31)
Lesson 5 – Manually Clean DIS Sensor (1:24)
Lesson 6 – Calibrate DIS Sensor (2:12)
Lesson 7 – Sending a 4-20 mA Output (0:51)
Lesson 8 – Controlling Via a 4-20 mA Output (1:29)
Lesson 9 – Control Via a Relay (0:45)
Lesson 10 – Configure Alarm Settings (1:31)
Course 3 – Description
This course covers best-practices installation, settings input, and calibration. If you have any questions, please contact a Kuntze representative at support@kuntze.com.
Ready for start-up? Check out Kuntze’s Registration and Start-Up Tutorial.